|
|
| Escapee Given Prison Time |
| By Teresa Lee, Wellington Daily News |
| Published: 01/29/2010 |
|
Wellington, Kan. —An inmate who escaped from the Sumner County Jail and spent days on the run has been sentenced to 14 months in prison for his escape. Jared M. Sanchez, 30, escaped from the Sumner County Jail at 6:26 p.m., Aug.7th, 2009 after he was brought in for a parole violation from Louisiana. Sanchez was apprehended without incident at a home near 63rd and Rock Road in Derby on Aug. 10. At the time of the escape, Sanchez was in the booking room secured to a bench with shackles, Sumner County Undersheriff Jerry Osborn said. According to the undersheriff, the detention officer in the room left to go to the sallyport, and during that time Sanchez was able to free himself from the bench, following the detention officer out into the sallyport. It was there, Osborn says, Sanchez struck the detention officer, taking him by surprise and knocking him to the ground. Sanchez then lifted the sallyport door about a foot or so to slide under it and escape, Osborn said. The day after the escape, officers received a tip reporting the inmate had been staying at a residence in town, Osborn said. While responding to the tip, Sanchez left the residence going south. Tracking him by GPS signals on this cell phone, officers pinned Sanchez down — seeing him moving south on US 177 near Hunnewell. Around that time, Oklahoma authorities were notified of Sanchez and his escape the day before. The Kay County Sheriff’s Department and the Oklahoma Highway Patrol set up in the Braman, Okla., area to find Sanchez and did — pursing him southbound on I-35 into Blackwell. After moving in several directions, Sanchez turned onto a country road and started shooting at the Kay County deputies in pursuit of him. After crossing a bridge, Sanchez crashed his vehicle and fled on foot, eluding law enforcement officials for a second time. The manhunt continued Monday for Sanchez as law enforcement officials continued to search in Oklahoma. Cell phone signals were used again to trace Sanchez to the home in Derby. Sanchez stood before Judge Scott McQuin Thursday morning, with Defense Attorney Michael Brown. The Louisiana man pleaded guilty to attempted aggravated escape from custody on Dec. 17, 2009, waiving his right to a preliminary hearing. McQuin explained the standard sentence is 14 months of presumptive probation, though a special rule application can allow the court to place the inmate under a prison sentence if the inmate escaped while incarcerated for a felony. Sumner County District Attorney Evan Watson said the court should sentence Sanchez to the standard 14-month sentence, to run consecutive to the time he is already serving for his original charges. Brown agreed with the sentencing suggested. McQuin, after trying to clarify Watson’s request, called a short recess. Upon returning from the recess, Sanchez got time to speak to the court. “I would just like to formally apologize to Sumner County...and ask that y’all consider the possibility of parole,” Sanchez said. The inmate went on to say he came to Wellington to take care of his father, who is “in poor health,” and that before the escape, he was a productive member of society, working at Cornejo & Sons and helping to construct Kellogg Road in Wichita. Sanchez says the whole event is a “misunderstanding.” “My parole was supposed to be transferred through an interstate contract but they said they never got in touch with Kansas parole. If you put me on probation, it would be easier to merge the two paroles,” Sanchez told McQuin. The judge denied the request for probation from Watson, Brown and Sanchez, requiring 14 months in the custody of the Department of Corrections with the possibility of 20 percent good time reduction. Read More. |
Comments:
Login to let us know what you think
MARKETPLACE search vendors | advanced search
IN CASE YOU MISSED IT
|
Rotary all kinds of sensor must be mounted on the shaft. An integral slip ring assembly is used to transfer the electrical signal from rotating electronics to Nagano keiki Pressure sensor stationary electronics. The slip ring consists of brushes which rub on rotating ring, providing an electrical path for the incoming excitation and the outgoing signal voltage. At low to moderate speeds the abs speed sensor electrical connection between the rings and brushes are relatively noise free, but at higher speeds noise will severely degrade their performance.FORD SERIES LAND ROVER SERIES Typical max speeds will be in the 5000 rpm range for a medium capacity torque sensor. Finally, the brush ring interface is a source of mazda 6 suction control valve torque that can be a problem especially for very low capacity measurements where the driving torque will have trouble overcoming the brush drag. Proximity and displacement suction control valve can also detect torque by measuring the angular GM SERIES displacement between shaft's two ends. By fixing two identical toothed wheels to the shaft at some distance apart Speed Sensor the angular displacement caused by the torque can be measured. Proximity Pressure Sensor or photocells located at each toothed wheel produce output voltages whose phase difference increases as the torque twists the shaft.FIAT SERIES
Hiện nay, có rất nhiều phương pháp để xác định giới tính của thai nhi, trong đó phương pháp xét nghiệm máu để biết trai hay gái là một trong những cách cho kết quả khá chính xác với tỷ lệ lên đến 95%. Xem thêm tại blog chăm sóc sức khỏe mang thai.